20A UM001 EN P PDF

Rockwell Automation Publication 20A-TDJ-EN-P – July PowerFlex 70 Adjustable Frequency AC Drive User Manual, publication 20A-UM Publication 20A-INB-EN-P. The PowerFlex 70 drive contains protective MOVs and Common Mode. Capacitors referenced to ground (see below). To guard. posts; United States. Posted 1 Jun ยท llautomation. com/idc/groups/literature/documents/um/

Author: Malahn Meztikus
Country: Greece
Language: English (Spanish)
Genre: Environment
Published (Last): 22 March 2016
Pages: 20
PDF File Size: 11.51 Mb
ePub File Size: 6.19 Mb
ISBN: 738-8-45790-363-8
Downloads: 79925
Price: Free* [*Free Regsitration Required]
Uploader: Voodoojin

The information provided Does Not replace the User Manual and is intended for qualified drive service personnel only. Deutsch Dieses Instruktionsblatt kann in mehreren Sprachen unter http: Step 1 Read the General Precautions To avoid an electric shock hazard, verify that the voltage on the bus capacitors has discharged before performing any work on the drive.

Other objects can occupy this space; however, airflow must not be reduced and inlet air temperature must not The drive has been listed by U. Specific drive catalog numbers are listed below: Most drives will have a jumper storage area inside the front cover. Extra jumpers or jumpers that have been removed should be stored in this location for use at a later time. If present, simply remove the protective cover, install or remove jumper and replace cover. Do not reduce wire gauge when using higher temperature wire.


The status of this input is interpreted by drive software.

If the application requires the drive to be disabled without software interpretation, a hardware enable configuration can be utilized. If the Safe-Off board is removed from the drive, pins 3 and 4 of the Safe-Off Connector must be jumpered for the drive to run. Factory default setting is 12 volts. See page 39 for information uum001 other start-up routines. When prompted, select a display language. Press the Enter key to display the Start-Up Menu. Not Selected Main Menu: PowerFlex 70 Start-Up Make a selection 1.

If you have an LCD HIM, two methods are provided, allowing the user to select the desired level needed for the application. Start During a Start Up, the majority of applications require changes to only a few parameters. With these parameters, you can set the following functions Steady Drive running, no faults are present.

Rockwell Automation 20A PowerFlex 70 Power Jumpers User Manual | 6 pages

Yellow Flashing, An inhibit condition 20, the drive cannot be started. Drive Stopped Check parameter [Start Inhibits]. If the source is an analog input, check wiring of the command.

Press Esc to acknowledge the fault. Address the condition that caused the fault. The cause must be corrected before the fault can be cleared. Also See for PowerFlex 70 Reference manual – pages User manual – pages Installation instructions manual – 56 pages.


Page of 52 Rn.

How to replace PowerFlex 70?

When reading this document, look for this symbol “. Start-Up of the PowerFlex The information provided Does Not replace the 02a Manual and is. For detailed PowerFlex 70 information including advanced start-up. To order paper copies of technical documentation, contact your local.

Rockwell Automation distributor or sales representative. To find your local Enn Automation distributor, visit. Allen-Bradley Drives Technical Support. Table of Contents Add to my manuals Add. Enhanced and ethernet plc-5 programmable controllers pages. Powerflex series medium voltage ac drives pages.

Page 40 Running S.


Comments to this Manuals Your Name. Enter text from picture: By pressing ‘print’ button you will print only current page.

To print the manual completely, please, download it. Don’t show me this message again. Got it, continue to print. Don’t have an account?