LPC2148 INTERFACING WITH LCD PDF

In this tutorial we will see how to interface a 16×2 LCD with ARM7-LPC microcontroller and display a simple welcome message. presented in this paper is the interfacing of LCD with ARM controller LPC to display a suitable text message on the. LCD. The text message ‚ÄúDYNAMIC. I think there is no more need to introduce how to interface LCD with microcontroller because we earlier learnt it. So in this module we learn how to interface LCD.

Author: Zuluzragore Faenos
Country: Azerbaijan
Language: English (Spanish)
Genre: Technology
Published (Last): 17 March 2012
Pages: 70
PDF File Size: 17.69 Mb
ePub File Size: 8.50 Mb
ISBN: 199-9-44361-883-2
Downloads: 66752
Price: Free* [*Free Regsitration Required]
Uploader: Arabar

Interfacing LCD with ARM(LPC21XX) in 4-bit mode

As lpcc2148 the name the 2×16 has 2 lines with 16 chars on each line. Here each character is displayed in a matrix of 5×7 pixels. Apart from alphanumeric chars it also provides the provision to display the custom characters by creating the pattern.

As shown in the above figure and table, an alphanumeric LCD has an 8-bit data bus referenced as D0-D7.

  LM324AM DATASHEET PDF

Interfacing LCD with LPC | EngineersGarage

This pin is used to send the enable trigger to LCD. Below schematic shows the minimum connection required for interfacing the LCD with the microcontroller.

As we are interfacing the LCD in 4-bit mode, only the higher 4 data lines are used as the data bus. Below table shows the LCD pins lp2148.

Interfacing 16×2 LCD with ARM7-LPC in 4-Bit Mode

The below configuration is as per the above table. First let’s see the timing diagram for sending the data and the command signals RS,RW,ENaccordingly, we write the algorithm and finally the code. The below image shows the timing diagram for sending the data to inferfacing LCD. As shown in the witth diagram the data is written after sending the RS and RW signals.

It is still ok to send the data before these signals.

The only important thing is the data should be available on the databus before generating the High-to-Low pulse on EN pin. The timings are similar as above ocd change is that RS is made high for selecting Data register. In the above tutorial, we just discussed how to interface 2x16Lcd in 4-bit mode. For that you need to include the lcd.

  JUNIPER SSG5 PDF

After including these files, the only thing you got to llcd is to configure the PORTs in lcd. The below sample code shows how to use the already available LCD functions. Download the complete project folder from this link.

Have an opinion, suggestionquestion or feedback about the article let it out here! Please enable JavaScript to view the comments powered by Disqus.

Retrieved from ” https:

admin